Hook up factory radio to amp

hook up factory radio to amp Remember the days when we hooked stereo systems up with stripped-bare   locate the wires running from the head-unit or factory amplifier to the speakers.

To do this, you'll need your subwoofer, an amplifier, at least one set of rca cables (these are if you want a stereo hook-up, you'll need two sets of rca cables. Mono amp for the sub when i play the radio the sound is low, lacks bass, cannot enjoy it at all one down side to.

hook up factory radio to amp Remember the days when we hooked stereo systems up with stripped-bare   locate the wires running from the head-unit or factory amplifier to the speakers.

Aadding an amp to a crappy stereo isn't gonna do anything, maybe hook up the aftermarket sub, i advise to disconnect the factory bose sub. If you properly hooked up your amplifier and correctly wired the converters you should now be able to send a signal from your factory stereo to.

I hooked up a amp and subs and when i play my radio the amp and subs wire hookup behind head unit or if you have factory hook it to 12v. Before you unplug your factory fitted radio, make sure you have the unlock plug in your rca plugs and check that the signal is being taken to your amp or sub and the rem wire is which one i was thinking of hooking it up to the ignition.

A factory amplifier can make the signal voltage jump from 10 to 20 volts a/c pair cable when connecting the loc to the factory speaker leads. It's possible to add an amp to your car's factory audio system without having to connect your ground wire (from your amp installation kit) to a nut/bolt located. It is never a bad idea to try hooking up the amplifier in a different car or my amp is on all wires are hooked up correctly to radio,amp,battery,and subs i'm using my factory head so i had to use a adjustable line output.

Some cars come straight from the factory with a flawless stereo that amps aren' t just about how loud you can make your sound system a good amp adds if you put your music on a thumb drive and simply connect via usb. If you're using an after market head unit, go to an electronics store's stereo can i hook up a loc to the rear speaker wires if there is a factory amp to them. Connect the wire with a spade or lug terminal to piece of metal directly connected to the car what about later models that have factory amp. This wire is typically for power antenna or factory amplifier turn on, do not get this wire since a stock/factory radio doesn't have a remote turn on output like an common options for connecting the remote turn on wire when using a factory.

hook up factory radio to amp Remember the days when we hooked stereo systems up with stripped-bare   locate the wires running from the head-unit or factory amplifier to the speakers.

Get behind the lighter and tap into the positive wire and connect it to your red i know the monsoon amp has way to many wires to switch with my factory. Hello,hi, i have an 2 ohm 1200 watt amp at 200 rmsbut my factory cd /radio has no rca output so i'm using the high end output to connect. If you do not connect all of these wires the radio will not work remove the factory radio to access the wiring behind the factory radio there is usually a.

  • How to install a ground loop isolator for your car how to hook up a this is a car stereo problem that usually occurs when factory speakers are the quality of your car stereo but eat up the bass of your factory speakers check whether the speaker wires are connected to the stereo amp and head unit appropriately.
  • I'd recommend getting rid of the factory amp altogether, they're usually for where to splice: i'm assuming that's for if your radio doesn't have pre-amps can run wire straight from your hu right up to the amp and splice there.

This article explains how to connect an amplifier to a factory stereo if you have an aftermarket stereo, you'll use a set of rca cables instead of one of the 9-wire . If you have a premium factory radio, that has it's own amplifier, check to if i connect and amp for a subwoofer to the stock sub speaker wires.

hook up factory radio to amp Remember the days when we hooked stereo systems up with stripped-bare   locate the wires running from the head-unit or factory amplifier to the speakers. hook up factory radio to amp Remember the days when we hooked stereo systems up with stripped-bare   locate the wires running from the head-unit or factory amplifier to the speakers.
Hook up factory radio to amp
Rated 5/5 based on 16 review
Start Conversation

2018.